Do not touch any electrical switch; do not use any phone in your building. Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions. If you cannot reach your gas supplier, call the fire de- partment. G40UH(X) SERIES GAS FURNACE Litho U.S.A. 503,991M $!...
Page 2
G40UH(X) Parts Identification TOP CAP FLUE COLLAR COMBUSTION AIR INDUCER UPPER ACCESS PANEL BURNERS SURELIGHT CONTROL BOARD BLOWER ACCESS PANEL WARNING Product contains fiberglass wool. Disturbing the insulation in this product during installation, maintenance, or repair will expose you to fiberglass wool. Breathing this may cause lung cancer.
Your furnace is a gas appliance. It is critical that the gas supplied to the unit be completely burned to avoid the pro- duction of carbon monoxide gas.
Page 4
3 - Turn off all electrical power to the unit. THERMOSTATS FIGURE 2 4 - This furnace is equipped with an ignition device which automatically lights the burners. Do not try to light the burners by hand. 5 - Remove the upper access panel.
Remove any ob- structions. Inspect the furnace venting system to make sure it is in place, physically sound, and without holes, corrosion, or blockage. Vent connector must be in correct position, sloped upward and be physically sound without holes or excessive corrosion.
Fresh air grilles and louvers (on the unit and in the room where the furnace is installed) - Must be open and unob- structed to provide combustion air. Burners - Must be inspected for rust, dirt, or signs of water.