Toshiba e-Studio 351c Operator's Manual For Basic Function page 272

6.Error Code (Cont.)
Scan Job
Error code
Remote Scan
2A20
2A40
2A50
2A51
Scan to E-mail
2C10, 2C12,
2C13, 2C20-
2C22
2C11, 2C62
2C14
2C15
8
2C30-2C33
2C40
2C43
2C61
2C63, 2C64
2C65, 2C66,
2C69
2C6A
2C6B
2C6C
270
8.JOB STATUS
Problem
Failed to acquire
resource
System fatal error
Job cancelling
Power failure
Illegal job status
Not enough memory
Invalid parameter spec-
ified
Message size
exceeded limit or maxi-
mum size
Disk access error
Failed to convert image
file format
Encryption error. Failed
to create file.
Failed to read Address
book
Invalid domain address
Failed to connect to
SMTP server
Failed to send E-mail
message
Invalid address speci-
fied in From: field
Invalid address speci-
fied in To: field
Perform the job in error again.
If the error still occurs, turn the power OFF and then back ON.
Perform the job in error again.
Turn the power OFF and then back ON. Perform the job in error
again.
Job was cancelled.
Check if the power cable is connected properly and it is inserted
securely. Check if the power voltage is unstable.
A system error has occurred during sending an E-mail. Retry it.
If the error still occurs, contact your service representative.
When there are running jobs, perform the job in error again after
the completion of the running jobs. If the error still occurs, turn
the power OFF and then back ON, and perform the job again.
Make sure you specify the settings correctly and try again.
Fragment the message into several smaller-sized ones and
send them again.
When there are running jobs, perform the job in error again after
the completion of the running jobs. If the error still occurs, turn
the power OFF and then back ON, and perform the job again.
Turn the power OFF and then back ON.
Retry the scan. If the error still occurs, contact your service rep-
resentative.
Perform the job in error again.
If the error still occurs, turn the power OFF and then back ON.
Perform the job in error again.
Turn the power OFF and then back ON.
Retry the job in error. Reset the data in the Address book and
retry it. If the error still occurs, contact your service representa-
tive.
Ask your administrator to set the IP address.
Make sure the SMTP server is correctly working, or the SMTP
server address has been set correctly. Then retry the scan.
Turn the power OFF and then back ON. Retry the scan. If the
error still occurs, contact your service representative.
Ask your administrator to check the SMTP Authentication
method or if there is an illegal character in the Terminal mail
address. Set the correct SMTP Authentication method or delete
the illegal character in the Terminal mail address.
Check if there is an illegal character in the Destination E-mail
address. Delete the illegal character and reset the appropriate
Destination E-mail address, then perform the job again.
What to do