Error Displays - Clarion CX501 Service Manual

11-2. Actuator
The actuator has a powerful magnetic circuit. If a magnetic
material is put close to it. Its characteristics will change.
Ensure that not foreign substances enter through the ventila-
tion slots in the cover.
COMPONENTS
PE-3402B-A/B/PE-3402K-A/B
1. Source unit
2. Extension lead
3.Parts bag
3-1. Screw(M5x8)
3-2. Machine Screw(M5x8)
3-3. Finisher(PE-3402B-A/
PE-3402K-A/B)
3-4. Spacer
3-5. Double face
4. Remote control unit(PE-3402B-A)
(including battery CR2025)

ERROR DISPLAYS

If an error occurs, one of the following displays is displayed. Take the measures described below to eliminate the problem.
Error Display
ERROR 2
CD/MP3/
ERROR 3
WMA
ERROR 6
ERROR 7
(iPod mode)
ERROR 7
USB/iPod
ERROR 7
* If an error display other than the ones described above appears, press the reset button.
* iPhone can also be connected to this system and "iPod" appearing in this manual should be referred to as "iPod/iPhone".
1
854-6487-50 1
1
716-0496-51 8
714-5008-4B 8
383-0591-00 1
340-1581-00 8
347-3913-20 2
RCB-176-600 1
Cause
A CD is caught inside the CD deck and is not
ejected.
A CD cannot be played due to scratches, etc.
A CD is loaded upside-down inside the CD deck
and does not play.
The connected iPod is not recognized.
Overcurrent detection.
Do not support the HUB devices.
11-3. Cleaning the lens
Dust on the optical lens affects performance.
To clean the lens, apply a small amount of isopropyl alcohol
to lens paper and wipe the lens gently.
CAUTION
Use of controls, adjustments, or performance of procedures other
than those specified herein, may result in hazardous radiation ex-
posure. The compact disc player should not be adjusted or repaired
by anyone except properly qualified service personnel.
CX501
FCC ID: WY2PE3402BA IC: 419E-CX501
Bluetooth QD ID: B017472
XXXXXXX
PE-3402B
This is a failure of CD deck's mechanism.
Replace with a non-scratched, non-warped disc.
Eject the disc then reload it properly.
Disconnect and reconnect the iPod.
Disconnect the devices and reconnect. If the devices
are still not recognized, try replacing with a different
devices.
Do not use the HUB devices.
-3-
Bottom view of PE-3402B-A
276-0793-00
MADE IN CHINA
Measure
CX501/CX501B/CX501A