Error Displays; Specifications - Clarion CZ305AU Owner's Manual & Installation Manual

Bluetooth cd/usb/mp3/wma receiver
Table of Contents

Advertisement

7. ERROR DISPLAYS

If an error occurs, one of the following displays is displayed.
Take the measures described below to solve the problem.
Display
Cause
Disc is inserted incorrectly.
ERROR 3
The disc format is not supported.
ERROR 5
This is a failure of deck's mechanism.
If an error display other than the ones described above appears, press the
problem persists, turn off the power and consult your store of purchase.
[RESET]
* When the
button is pressed, frequencies of radio stations, audio setting, etc. stored
in memory are cleared.
14
CZ305AU
Measure
Eject the disc then reload it properly.
Try another disc.
Consult your store of purchase.
[RESET]
button. If the

8. SPECIFICATIONS

FM Tuner
Frequency range: 87.5 - 108.0MHz
Usable sensitivity: 12dBf
Frequency response: 30Hz-15kHz
Stereo separation: 30dB(1kHz)
Signal/noise ratio: >55dB
AM Tuner
Frequency range: 531 - 1629KHz
Usable sensitivity (S/N=20dB): 30dBμ
CD Player
System: Disc digital audio system
Frequency response: 20Hz-20kHz
Signal/noise ratio: >94dB
Total harmonic distortion: Less than 0.1% (1kHz)
Channel separation: >60dB
MP3/WMA mode
MP3 sampling rate: 8 kHz to 48 kHz
MP3 bit rate: 8 kbps to 320 kbps / VBR
WMA bit rate: 8 kbps to 320 kbps
Logical format: ISO9660 level 1,2
Joliet fi le system
USB
Specifi cation: USB 1.0/2.0
Playable audio format:
MP3(.mp3): MPEG 1/2/Audio Layer-3
WMA(.wma): Ver 7/8/9.1/9.2
Bluetooth
Specifi cation: Bluetooth Ver. 2.1+EDR
Profi le: HFP (Hands-free Profi le)
A2DP (Advanced Audio Distribution Profi le)
AVRCP (AV Remote Control Profi le)
PBAP (Phone Book Access Profi le)
Send/Receive Sensitivity: Class 2
Audio Amplifi er
Maximum power output:
180W (45W x 4)
Speaker impedance: 4
(4 to 8
allowable)
Input
Audio input sensitivity:
High: 320mV (at 1V output)
Mid: 650mV (at 1V output)
Low: 1.3V (at 1V output)
(input impedance 10 k
or greater)
Aux-in level: ≤2V
General
Power supply voltage:
14.4VDC (10.8 to 15.6V allowable),
negative ground
Pre-Amp output voltage:
2.0V (CD play mode: 1kHz, 0dB, 10k
load)
Fuse: 15A
Dimensions of the Main Unit:
188mm Width × 58mm Height × 179mm Depth
Weight of the Main Unit: 1.20kg
178mm
50mm
170mm
46mm
188mm
58mm
Note:
• Specifications and design are subject
to change without notice for further
improvement.

Advertisement

Table of Contents
loading

Table of Contents