Specifications - Whitfield II-T C FS Installating And Operation Manual

SPECIFICATIONS

- Advantage II-T C FS
Flue Size
Width, Overall
Depth, Overall
Depth, Overall w / 3" tee
Height
Floor to Rear
Flue Center
Facing Back of Unit,
outside edge on right
to center of rear
flue outlet
Floor to Rear
Outside Air Inlet
Facing Back of Unit
outside edge on right
to center of air inlet
Floor Protection
Requirements
Standard Features
Hopper Capacity
Burn time
Fuse, Control Board
Fuse, Igniter
Heat Input (Max.)
Emissions
Ship Weight
Room Air Blower
Auger Motor
Exhaust Blower
Options
3" Standard
24 3/4"
25" (26" to flue outlet)
30 7/8"
31 3/8"
17 1/2"
5 15/16"
11"
13 1/2"
+ 6" Front & Sides
& up to * 6" for the Back
Fastfire Self Igniter
Wall Thermostat
(wire included)
70 lbs.
♦ 15.5 - 54 hours
5 Amp, 250 volt, 3AG *
6 Amp, 250 VAC *
♦ 11,000 - 38,000 BTU / hr
♦ 2.3 gr / hr (varies w / size
and type of fuel) EPA
Certified
225 lbs.
150 CFM;1.5 Amps,
3000 rpm
1 RPM; .55 Amps
95 CFM: .95 Amps,
3000 rpm
Log Set
Gold Trivet
www.PelletKing.com
SIDE VIEW ILLUSTRATION
BACK VIEW ILLUSTRATION
31 3/8"
17 1/2"
11"
Note: Dimensions shown are approximations only (+/-
1/4")
+ Non-combustible thermal rated floor protection must
be used when installed on carpet (see Floor Protec-
tion, page 5). When installed at clearances less
than 6", the floor protector is only required to ex-
tend to the wall.
♦ Fuel delivery and burn times will vary depending
on size and type of fuel used. Estimated heat in-
put based on fuel value of 8400 BTU per lb. Fuses
are rated as fast blow.
PAGE 31
30 7/8"
25"
24 3/4"
24 3/4"
5 15/16"
7 9/16"
13 1/2"
9"