Millivolt Appliance Checkout - Lennox Hearth Products CI1500DVF Series Care And Operation Instructions Manual

9. Place the glowing embers on the burner
as shown in fi gures 17 & 18.
One package of ember material has been
included with this log set You will not need
to use the entire bag.
IMPORTANT: The quantity and placement of the
ember material can affect stove performance
therefore it is very important that it be placed
17 & 18
as shown in fi gures .
a. Unpackage and divide the fi ne ember material
(mineral wool) into dime-sized fl uffy pieces.
b. Distribute the pieces over the top of the
front burner ports. Avoid covering the slots
and fi lling the area in front of the forward logs
(see fi gure 18).
Embers
Figure 17
DO NOT PLACE EMBERS ON TOP OF THE
BURNER SLOTS.
Figure 18
SIT Millivolt Appliance Checkout
The pilot fl ame should be steady, not lifting
or fl oating. Flame should be blue in color with
traces of orange at the outer edge. The top 3/8"
(10 mm) at the pilot generator (thermopile)
and the top 1/8" minimum (tip) of the quick
drop out thermocouple should be engulfed
in the pilot fl ame. The fl ame should project 1"
(25 mm) beyond the hood at all three ports
(Figure 19).
Replace logs if removed for pilot inspec-
tion.
To light the burner, rotate the gas valve control
knob counterclockwise to the "ON" position
then turn "ON" the on/off rocker switch.
Proper Pilot Flame Appearance
MILLIVOLT Hood Igniter Rod
Thermocouple
Pilot
Nozzels
Thermopile
Figure 19
With proper care and maintenance, your appli-
ance will provide many years of enjoyment. If
you should experience any problem, fi rst refer
to the troubleshooting guide in this manual.
If problem persists, contact your Lennox
distributor.
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
Small Area Paint Touch-up
(Black Painted Stoves Only)
The stove body is painted with a quality high-
temperature stove paint. Only use factory sup-
plied Stove Paint for touch-ups (70K99).
Using one small piece of 320 grit sand paper
and lightly sand the blemish so that the edges
are "feathered" or smooth to the touch between
the painted and bare sur-faces. Do not let the
sand paper gum up with paint, as this will
cause scratches on the metal surface. If there
are any scratches, use 600 grit sandpaper
instead. Mask off surfaces you do not want
painted. Paint lightly over the bare surface
fi rst as this will act as an under-coat. Then
paint over a larger area in smooth even strokes
to blend.
See Burn-In Period on page 4 for information
on curing the paint.
3/8" Min.
(9 mm)
9