Log Placement; Fiber Chunks Placement; Millivolt Appliance Checkout - Lennox Hearth Products EBVCLNE Homeowner's Care And Operation Instructions Manual

Log Placement

WARNING: LOG SET GETS VERY HOT
AND WILL REMAIN HOT UP TO ONE
HOUR AFTER GAS SUPPLY IS TURNED
OFF. HANDLE ONLY WHEN LOG SET IS
COOL. TURN OFF ALL GAS TO THE
APPLIANCE BEFORE INSTALLING THE
GRATE AND LOG SET.
WARNING: THIS APPLIANCE IS NOT DE-
SIGNED TO BURN WOOD. ANY ATTEMPT
TO DO SO COULD CAUSE IRREPARABLE
DAMAGE TO YOUR APPLIANCE AND
PROVE HAZARDOUS TO YOUR SAFETY.
WARNING: THE SIZE AND POSITION OF
THE LOG SET WAS ENGINEERED TO GIVE
YOUR APPLIANCE A SAFE, RELIABLE
AND ATTRACTIVE FLAME PATTERN. ANY
ATTEMPT TO USE A DIFFERENT LOG SET
IN THE FIREPLACE WILL VOID THE WAR-
RANTY AND WILL RESULT IN INCOM-
PLETE COMBUSTION, SOOTING, AND
POOR FLAME QUALITY.
The log set is located within the firebox area.
One plastic bag of glowing embers, one plastic
bag of decorative volcanic stone and one bag of
vermiculate, is located in the bottom compart-
ment. Refer to the Log Placement Guide supple-
ment for detailed placement instructions. See
Figure 9 for vermiculate and glowing embers
placement.
FIREBOX BOTTOM
BACK OF FIREPLACE
Figure 8
Figure 9
BURNER POSITIONING
PILOT ASSEMBLY
Figure 10
PAN BURNER
Install the vermiculite, decorative volcanic
stone and glowing embers (rockwool)-
Spread vermiculite on the simulated brick floor
of the firebox around the burners to simulate
ashes. Maintain a
tom of the horizontal grate section and the top
of the pile of vermiculite. Sprinkle the decora-
tive volcanic stone on the vermiculite as shown
in Figure 9.
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
Glowing Embers
(Rockwool)
PAN
BURNER
in. gap between the bot-
Vermiculate And Volcanic
Stone On Firebox Bottom
Place a few dime-sized pieces of rockwool on
the pan burner in front of the burned out area
on both sides of the log set. The pieces of
rookwool may touch one another, but should
not overlap each other.

Millivolt Appliance Checkout

The pilot flame should be steady, not lifting or
floating. Flame should be blue in color with
traces of orange at the outer edge.
The top " (10 mm) at the pilot generator
(thermopile) and the top " min (tip) of the
quick drop out thermocouple should be en-
gulfed in the pilot flame. The flame should
project 1" (25 mm) beyond the hood at all three
ports. See Figure 11.
To light the burner, refer to the lighting in-
structions on pages 14 and 15.
9