Hazard Warning Lamps - Mercedes-Benz G-Class Operator's Manual

Exterior lighting
104
High-beam flasher
High-beam headlamps
:
Turn signal, right
;
High-beam flasher
=
Turn signal, left
?
X
To switch on: turn the SmartKey in the
ignition lock to position 1 or 2 or start the
engine.
X
Pull the combination switch briefly in the
direction of arrow =.

Hazard warning lamps

X
To switch on the hazard warning lamps:
press button :.
All turn signals flash. If you now switch on
a turn signal using the combination switch,
only the turn signal lamp on the
corresponding side of the vehicle will flash.
X
To switch off the hazard warning
lamps: press button :.
The hazard warning lamps automatically
switch on if:
an air bag is deployed
R
the Emergency Tensioning Devices are
R
triggered, or
the vehicle is slowed down rapidly from a
R
speed of over 45 mph (70 km/h) and
comes to a halt
The hazard warning lamps switch on
automatically if an air bag or the Emergency
Tensioning Devices are triggered and the
SmartKey is in position 1 in the ignition lock.
The hazard warning lamps switch off
automatically if the vehicle reaches a speed
of over 6mph (10km/h) again after a full
brake application.
i The hazard warning lamps still operate if
the ignition is switched off.
Cornering light function
The cornering light function improves the
illumination of the road over a wide angle in
the direction you are turning, enabling better
visibility in tight bends, for example. The
cornering light function can only be activated
if the low-beam headlamps are switched on
and the fog lamps are switched off.
Active: if you are driving at speeds below
25 mph (40 km/h) and switch on the turn
signal or turn the steering wheel
Not active: if you are driving at speeds above
25 mph (40 km/h) or switch off the turn