Machine Elements - Bosch GWS 7-115 Operating Instructions Manual

Speed Preselection (Type CE)
Material Application
Plastic Polishing
Finish polishing
Metal Finish grinding
Removing paint
Wood, Metal Brushing, Removing rust
Metal, Stone Grinding
Metal Roughing
Stone* Cutting*
* Cutting of stone is permitted only with the cutting guide (accessory).

Machine Elements

1 Thumbwheel for speed preselection
(Type CE)
2 On/Off switch
3 Auxiliary handle
4 Spindle lock
5 Grinder spindle
6 Protective guard
7 Clamping lever
8 Mounting flange with O-ring
9 Roughing/cutting disc*
10 Clamping nut
11 quick clamping nut*
12 Hand protector*
13 Rubber sanding plate*
14 Sanding disc*
15 Round nut*
16 Cup brush*
17 Cutting grinder stand*
18 Length stop*
19 Diamond cutting disc*
20 Cutting guide with protective vacuuming
hood*
* Accessories
* Not all of the accessories illustrated or described are
included as standard delivery.
Intended Use
The machine is intended for cutting, roughing and
brushing metal and stone materials without using
water. For cutting stone, a cutting guide is re-
quired.
For machines with electronic control: With ap-
proved sanding tools, the machine can be used
for sanding and polishing.
15 • 1 609 929 C85 • TMS • 26.11.01
Tool
Lamb's wool hood
Felt polishing disk
Buffing disk
Sanding sheet
Cup brush, sanding sheet
Grinding disk
Roughing disk
Cutting disk and cutting guide
Wear protective glasses and hearing protec-
tion.
Wear protective gloves and sturdy shoes.
When necessary, also wear an apron.
The dust that is produced while working can be
detrimental to health, inflammable or explo-
sive. Suitable safety measures are required.
Examples: Some dusts are regarded as carci-
nogenic. Use suitable dust/chip extraction and
wear a dust respirator.
Dust from light alloys can burn or explode. Al-
ways keep the work place clean, as blends of
materials are particularly dangerous.
If the mains cable is damaged or cut through
while working, do not touch the cable but im-
mediately pull the mains plug. Never use the
machine with a damaged cable.
Connect machines that are used in the open
via a residual current device (RCD) with an ac-
tuating current of 30 mA maximum. Use only
extension cables that are approved for outdoor
use.
When working with the machine, always hold it
firmly with both hands and provide for a secure
stance.
Always direct the cable to the rear away from
the machine.
English - 2
Thumbwheel
1
1
1
2 – 3
3
4 – 6
6
6
For Your Safety
Working safely with this ma-
chine is possible only when the
operating and safety information
are read completely and the in-
structions contained therein are
strictly followed. In addition, the
general safety notes in the en-
closed booklet must be ob-
served. Before using for the first
time, ask for a practical demon-
stration.