Troubleshooting - Denon DCD-1520AE Owner's Manual

Contents

Troubleshooting

If a problem should arise, first check the following:
1. Are the connections correct?
2. Is the set being operated as described in the owner's manual?
3. Are the other devices operating properly?
If this unit does not operate properly, check the items listed in the table below. Should the problem persist, there may be a malfunction.
In this case, disconnect the power immediately and contact your store of purchase.
2 Power does not turn on / Power is turned off
Symptom
Power is not turned on.
Power automatically turns off.
2 Operations cannot be performed through the remote control unit
Symptom
Operations cannot be performed
through the remote control unit.
Front panel
Downloaded from www.Manualslib.com
Connections Playback
• Check whether the power plug is correctly inserted into the power outlet.
• This unit is in standby mode. Press POWER X on the remote control.
• The Auto Standby mode is set. When Auto Standby mode is set to On, if the unit remains in the
stopped state and no operations are performed or if there are no input signals for approximately 30
minutes, the unit automatically switches to standby mode.
• Batteries are worn out. Replace with new batteries.
• Operate the remote control unit within a distance of about 8 m from this unit and at an angle of
within 30°.
• Remove any obstacle between this unit and the remote control unit.
• Insert the batteries in the proper direction, checking the q and w marks.
• The set's remote control sensor is exposed to strong light (direct sunlight, inverter type fluorescent
bulb light, etc.). Move the set to a place in which the remote control sensor will not be exposed
to strong light.
• When using a 3D video device, the remote control unit of this unit may not function due to effects
of infrared communications between units (such as TV and glasses for 3D viewing). In this case,
adjust the direction of units with the 3D communications function and their distance to ensure they
do not affect operations from the remote control unit of this unit.
• Press REMOTE MODE CD button to switch the remote control to the CD operation mode.
Display Rear panel
manuals search engine
Settings
Cause / Solution
Cause / Solution
54
Remote
Appendix
Tips
Index
Page
25
27
51
Page
5
5
–
5
–
–
12