Denon DCD-1520AE Owner's Manual page 49

Contents
NOTE
• Perform operations such as playback and pause on the computer. At this time, you
cannot perform operations with buttons on this unit or the remote control.
• You can also control the volume and equalizer on the computer. Enjoy playing
music at the desired volume.
• When this unit is functioning as a D/A converter, sound is not output from the
computer's speakers.
• If the computer is disconnected from this unit while the computer music playback
software is running, the playback software may freeze. Always exit the playback
software before disconnecting the computer.
• When an abnormality occurs on the computer, disconnect the USB cable and
restart the computer.
• The sampling frequency of the music playback software and sampling frequency
displayed on this unit may differ.
• Use a cable that is 3 m or less to connect to the computer.
Front panel
Downloaded from www.Manualslib.com
Connections Playback
Display Rear panel
manuals search engine
Settings
Connect and playback from a digital
device (Coaxial/Optical)
1
Connect digital device to this unit (vpage 20).
2
Press SOURCE to select the playback media mode to
"COAXIAL" or "OPTICAL" (vpage 28).
The input digital audio signal is displayed as shown.
"COAX: xxxxk" or "OPT : xxxxk"
(xxxx is the sampling frequency.)
• The L.PCM indicator lights when a Linear PCM signal is detected.
• If the sampling frequency cannot be detected, "Unlock" will be
displayed.
2 Files that can be played back
• See "D/A converter" (vpage 61).
NOTE
• Do not input non-PCM signals, such as Dolby Digital, and DTS. This causes noise
and could damage the speakers.
• If the sampling frequency switches, such as from A mode to B mode in a CS
broadcast, muting may operate for 1 – 2 seconds, cutting the sound.
49
Remote
Appendix
Tips
Index