5-6．User-Selection Header/Terminator Setting - Denso HC36 II TU-K Operation Manual

5-6． ． ． ． User-selection Header/Terminator Setting
If you would like to use header/terminator character other than page
28 and 29, you can set header/terminator up to 4 characters.
◆Setting
Select the user-selection header (terminator) reading start label to
read hexadecimal label, from upper to lower digits of the given
characters, based on the user-selection header/terminator setting
table (See pages 35 to 36). When data entry is completed, read
the user-selection header (terminator) reading completion label
with the handy scanner.
If you would like to enable the user-selection header/terminator,
set the header/terminator user-selection at page of 28 and
29(follow the page 15.)
Ex.) For selecting a character at header "+Z"(hexadecimal digits : 2B,
5A)
User-selection header start
User-selection header completion
Setting start
User-selection Header
User-selection Terminator
User-selection header
Start
Start
2 B
(Two characters)
Completion
Completion
34
5 A
Setting completion