Denso HC36 II TU-K Operation Manual page 18

Parameter Setting Flow for Sections 5-2 to 5-5
"All defaults" (See NOTE below.)
N
End?
NOTE: "All Defaults" means that all setting parameters
(such as "Communication parameters", "Data transmission
format", "Reading codes" and "Other parameters") are
changed to default settings.
Start
"Start setting"
Beeps 3 times.
Set communication conditions.
Set transmission format.
Set readable codes.
Set other parameters.
Y
"End setting"
Beeps 3 times.
End
15
(See p.16 to 18.)
(See p.19 to 29.)
(See p.30 and 31.)
(See p.32 and 33.)