Invacare Action NG range Maintenance And Adjustment page 29

SECTION 8—ANTI-TIPPERS
Adjusting Anti-Tippers
NOTE: For this procedure, refer to FIGURE 8.2.
When anti-tippers are used, anti-tippers MUST be adjusted to maintain a 3 to 5 cm
clearance between the bottom of the anti-tipper wheels and the ground/ floor. This
spacing should always be checked whenever adjustments/changes are made to
the wheelchair.
Make sure that the anti-tipper wheel is ALWAYS located out side the rear wheel
volume.
Failure to maintain proper spacing may result in the chair tipping over backward
causing serious injury or property damage
1. Press the release buttons on the wheeled portion of the anti
down to achieve the 3 to 5 cm clearance.
2. Check to make sure that the release buttons are fully engaged in adjustment holes.
NOTE: Make sure that the anti-tipper wheel is ALWAYS located out side the rear
wheel volume.
Anti-tipper
wheel
W A R N I N G
FIGURE 8.2
3 to 5 cm Adjusting Anti-Tippers
FIGURE 8.2
Adjusting Anti-Tippers
2 9
tipper and slide it up or
-
Ac t i o n 1 N G R a n g e