Adjusting Quick-Release Axles; Replacing Handrims - Invacare Action NG range Maintenance And Adjustment

Adjusting Quick-Release Axles

NOTE: For this procedure, refer to FIGURE 5.3.
1. Remove rear wheel and quick
Removing/Installing Rear Wheels paragraph.
2. Depress detent pin in the quick
the rear wheel hub.
3. Release detent pin to ensure that the locking pins are fully released.
4. Increase or decrease end play by adjusting the locknut on the end of the quick release axle.
W A R N I N G
Make sure the detent pin of the
quick-release axle is fully released
BEFORE operating the wheelchair.
Keep locking pins clean. Always
make sure that the spacer is in place.
5. Reinstall rear wheel onto the
wheelchair. Refer to
Removing/Installing Rear Wheels
paragraph.
6. Repeat STEPS 4
release axle detent pins are fully
released past the wheelchair frame.

Replacing Handrims

NOTE: for this procedure, refer to FIGURE 5.4.
1. Remove the rear wheel from the wheelchair. Refer to Removing/Installing Rear
Wheels paragraph.
2. Remove the mounting screws that secure the existing handrim to the rear wheel.
3. Remove the existing handrim.
4. Install the new handrim and secure to
the rear wheel with the existing
mounting screws.
5. Reinstall the rear wheel to the
wheelchair. Refer to
Removing/Installing Rear Wheels
paragraph.
6. Repeat STEPS 1
if necessary.
Ac t i o n 1 N G R a n g e
release axle from the wheelchair. Refer to
-
release axle and slide the quick
-
5 until the quick-
-
5 for opposite wheel,
~
SECTION 5—REAR WHEELS/FRONT CASTORS
Wheelchair Frame
Spacer
FIGURE 5.3
Adjusting Quick-Release Axles
Rear Wheel
Handrim
FIGURE 5.4
2 0
release axle through
-
Locknut
Quick-Release
Axle
Replacing Handrims