Saeco Modular Coffee Instruction And Maintenance Manual page 8

English
Furthermore it is possible to dispose of the coffee grounds
directly into a container to be placed below the machine surface
top, as follows:
- drill the surface top as indicated (ref. E', fig. 6);
break the pre-marked diaphragm (ref. E, fig. 6) on the
bottom
of the grounds tray (ref. 17, fig. 1).
Important
In order to make connection operations easier, the
diameter of the holes to be drilled in the surface top
will have to be greater than that of the pipes and
cables indicated in the legend of fig. 6.
Legend:
A'
Adjustable feet
B'
Water drain (27 mm 0 tube)
C'
Water supply (19 mm 0 tube)
D' Power mains (1 3 mm 0 power cord)
E'
Coffee grounds tray
F' Single hole to replace holes B', C' and D'
(100 mm Ø pipe).
fig. 6
Danger
According to the norms ruling in the Country where the
machine is installed, the cord for the connection to the
mains must be equipped either by an all-pole switch
(with a minimum contacts' opening clearance of 3 mm),
or with a plug conforming to the norms.
The all-pole switch must be suitable for the power drawn
by the machine and able to detect all voltage polarities.
Check that the electrical cables of the installation are cor-
8
rectly proportioned to the power drawn by the machine.
The connection point (electrical socket or all-pole
switch) must be placed in a position easily reachable
by the user, in order to be able to disconnect the
machine from the mains, should this be necessary.
In case of installations with 400 V two-phase current, utilize
the phases in such a way as to supply the machine with 230
V single-phase current (fig. 7).
Connection of plug
to a 400 V2N~ two-phase mains line
CH
(Switzerland)
NB: For the 230V~ single-phase connection it is necessary to
use the special kit (code 1020.R05) and to follow the
instructions contained therein.
Only for EUROPEAN models
CEI