Panasonic CF-28 Series Reference Manual page 37

PC Cards
Label-side up
Inserting/Removing PC Card
Inserting PC Cards
Slide the PC Card in until it snaps into place. Refer to the operating instructions of
each card on how to Insert the card (insertion is typically label-side up).
CAUTION
When using a PC Card to connect a peripheral device (SCSI, IEEE 1394,
etc.):
1 Connect the peripheral device to the card.
2 Turn the device on.
3 Insert the card.
When inserting a card, do not force the card in if difficulty is encountered. You
may damage the slot, making it impossible to remove the card.
Removing PC Cards
CAUTION
Do not remove a PC Card while your computer is in the standby or hibernation
mode.
When two PC cards are inserted, perform the following procedure (from Step
to Step ) for each of the two cards.
Note that the operation of removing the PC Card may not be complete, de-
pending on the status of the PC Card or device connected to the PC Card,
such as when a SCSI card is used to connect an external hard disk to the
computer. In such cases, turn off the power from the [Start] menu, then re-
move the card.
Windows 2000
Double-click on the taskbar, select the PC Card, then select [Stop].
Follow the on-screen instructions.
(When the PC Card has been removed after the computer is turned off, this step
is not necessary.)
Windows XP
Double-click on the taskbar, select the PC Card, then select [Stop].
Follow the on-screen instructions.
(When the PC Card has been removed after the computer is turned off, this step
is not necessary.)
Press the button.
Slide the PC Card out.
37