Table of Contents
Advertisement
Description of the machine
Indicator lights for: Residual moisture /
Time left
Residual moisture (%)
Lights up when the machine is switched on
and a programme between
been chosen.
It goes out at the end of the programme.
Time left (h/mins)
Lights up when the machine is switched on
0
and programme
It goes out at the end of the programme.
Programme sequence, Check lights and
Fault indicators
On
Drying
Cool air
Anti-crease/End
Check venting
Check fluff filter
Fault indicators
Faults or interruptions are indicated by the
sequence lights or the check lights flashing.
Drying light
Fault in the heating system.
Action: Please contact G3 Systems.
Cool air light
The maximum running time of the drying
programme was exceeded because the
residual moisture at the start of the
programme was too high.
Action: Start the drying programme again.
If the fault message occurs again please call
G3 Systems.
1
9
and
has
!
or
has been chosen.
Check venting
The venting duct is blocked or badly restricted.
Action: Check the vent ducting and if
necessary clean it.
Check fluff filter
The fluff filter is clogged.
Action: Clean the fluff filter at the end of the
programme (I.A.W. Cat 601).
Note:
The "Drying", "Cool air" and "Anti-crease/End"
indicator lights flash if there is a power cut or if
a programme has been interrupted (e.g. when
a door has been opened and shut). They are
not indicative of a fault. The lights will stop
flashing when the "Start" button is pressed
again.
Emergency Stop switch
Only use this switch in an emergency.
Do not use it in normal operation to switch the
machine off.
To reset the Emergency stop switch after it
has been used, turn the ribbed disk clockwise.
9
«M.-Nr. 06 411 821 - GB - »
Hide quick links:
Advertisement
Table of Contents
