Table of Contents
Advertisement
2. Color frame retaining clip
The color frame holder is equipped with a spring-loaded retaining clip that prevents color frames and
accessories from falling out.
Warning! Hang the CDM PAR with the color frame retaining clip in the locked position
1. Release the retaining clip by pushing it sideways. The retaining clip opens.
2. Insert the color frame
3. press the retaining clip down until it locks.
Note: Use only color frames or top hats with 6.7 Inches inside diameter.
3. Cleaning the reflector
The following recommendations are offered when cleaning and inspecting lenses and reflectors.
Do not use glass and window cleaners on the reflector. Chemicals in these cleaners will ham the
reflective coatings.
Do not use paper towels or harsh materials to wipe the reflectors. These materials can scratch the
surface of the reflector.
Warning! Unplug the fixture before attempting to clean reflector.
1. Remove the lens so you can access the reflector from the front of the fixture. See removing a
lens in this manual.
2. Remove dust with a blast of oil free air, or wipe with a clean, soft, lint-free cotton cloth. If this is
sufficient to remove dust, go to step 5. otherwise continue with step 3.
3. Dampen a clean, soft, lint-free cotton cloth with a mild, soapy water solution and gently wipe
the reflector.
4. Remove any soapy water residue with a clean, soft, lint-free cotton cloth dampened with
water.
5. Reinstall a lens before using the fixture.
4 / 9
Advertisement
Table of Contents
