Setting The Current Day And Time; Setting The Event Setpoints; Push Button Auto Repeat - Johnson Controls T500HCP-1 User Manual

P
rogramming the Thermostat

Setting the Current Day and Time

To set the current day and time:
1. Press and release the Clock button.
The display will flash a day of the week.
2. Press the ∨ ∨ ∨ ∨ or ∧ ∧ ∧ ∧ buttons until the current day
shows.
3. Press Clock again. The display will flash the hour.
4. Press the ∨ ∨ ∨ ∨ or ∧ ∧ ∧ ∧ buttons until the current hour
shows. Be sure AM or PM corresponds to the
proper time.
5. Press Clock again. The display will flash minutes
(:00). (See Figure 21.)
6. Press the ∨ ∨ ∨ ∨ or ∧ ∧ ∧ ∧ buttons until the current minutes
show.
7. Press Clock to complete the procedure or wait
15 seconds to return to normal display.

Setting the Event Setpoints

Setpoints are programmed for both heating
cooling modes, and either two (day and night) or
four (morning, day, evening, and night) events per day.
(See Table 1.) To program a setpoint:
1. Press the Mode button until heat
2. Press the Set Temp button. The mode (heat
cool ), event (morning, day, evening, or night)
symbols, and the present setpoint will be
displayed.
3. Press the ∨ ∨ ∨ ∨ or ∧ ∧ ∧ ∧ buttons to adjust setpoints for the
displayed event and mode.
4. Press Set Temp to move to the next event. Press
the ∨ ∨ ∨ ∨ or ∧ ∧ ∧ ∧ buttons to adjust the setpoint. Repeat
this step until all event setpoints are programmed.
5. Press Mode until cooling
repeat Steps 2 through 4.
and
is displayed.
or
is displayed, and
T500 Series Programmable Thermostats Product/Technical Bulletin
6. Select the desired mode of operation: heat, cool,
auto.
7. When programming is complete, press the
Resume button to return to the normal display.
!
CAUTION: Equipment Damage Hazard.
Operating a cooling system
without proper limit controls in
very low outdoor air
temperatures can permanently
damage the cooling equipment.
Clock
Press to
set days,
hours, and
Set Temp
minutes.
Program
Hold
Figure 21: Setting the Current Day and Time

Push Button Auto Repeat

Holding the Program button down will advance you
through the programming menu in sequence to the
desired option.
Outdoor
66
Mode
Mo
Fan
AM
:0 0
Resume
17