Setting The Event Times; Scheduling 1-, 2-, 3- And 4-Event Days In The Same Week; Making Programming Changes While The Keyboard Is Locked - Johnson Controls T500HCP-1 User Manual

Setting the Event Times

To program event times:
1. Press and release the Program button. The
morning event symbol
appear.
2. Press the ∨ ∨ ∨ ∨ or ∧ ∧ ∧ ∧ buttons to select the first single
day or the first day of a block of days to be
programmed.
3. Press and release Program. Press the ∨ ∨ ∨ ∨ or ∧ ∧ ∧ ∧
buttons to set the start time hour for the first event.
4. Press and release Program. Press the ∨ ∨ ∨ ∨ or ∧ ∧ ∧ ∧
buttons to set the minutes in 10-minute intervals
(i.e., 8:10, 8:20, etc.).
5. Press Program to advance to the next event.
6. Repeat Steps 3 through 5 for all remaining events.
After programming the last event, press Program.
Copy will be displayed.
7. If you do not want to copy the program, press
Program and proceed to Step 9. To copy the
program, press the ∨ ∨ ∨ ∨ or ∧ ∧ ∧ ∧ buttons to select
individual days to copy the program to. The Copy
function will only allow program times to be copied
to sequential days (i.e., Tuesday, Wednesday,
Thursday).
8. Press Program to copy program settings to the
selected days of the week.
9. Repeat the procedures for Setting the Event Times
for any remaining unprogrammed days of the
week.
10. When finished, verify that all events are
programmed correctly by repeatedly pressing the
Program button. When Copy appears, press
Program to skip to the next day.
11. When programming is complete, press Resume to
return to normal display.
Note: See Table 7 for an example of programming
for a given week.
18 T500 Series Programmable Thermostats Product/Technical Bulletin
and the current day
Clock
Set Temp
Program
Press to
set hours,
minutes,
Hold
and
events.
Figure 22: Setting the Event Times
Scheduling 1-, 2-, 3- and 4-Event Days in
the Same Week
If the DIP switch is set for 4-event days, a 2-event day
can be programmed by setting the same event time for
consecutive events. See the example shown in
Table 7.
Making Programming Changes While the
Keyboard is Locked
To make programming changes while the DIP switch is
set to lock the keyboard:
1. Open the thermostat and switch the DIP switch to
unlock the keyboard. (See Table 1: DIP Switch
Selections.) Close the thermostat.
2. Make necessary program changes.
3. Open the thermostat and switch the DIP switch to
lock the keyboard again. Close the thermostat.
Outdoor
66
Mode
Mo
Fan
AM
5:00
Resume