Nikon ED 17-55mm f/2.8G IF Repair Manual page 79

⑯ The reconfirmation screen is displayed. Click "OK".
⑰ An hourglass is displayed on the screen, and writing starts.
The below screen is displayed after a few seconds. Turn camera OFF and turn it ON again.
Click "OK", and the adjustment software restarts.
Note: Unless the camera is turned off once, the value that was written in EEPROM is not reflected on
the results of shooting.
⑱ When the adjustment software restarts, perform the operations from ② to ⑬ again. Check that "0μm" of
the AF position is in focus.
(It is also possible, after Wide-side shooting of ⑫ , to take the Middle-side shooting of ⑩ and the Tele-side
shooting of ② .)
If "0μm" is not in focus, repeat the operations from ② to ⑱ .
If it is not still in focus even after repetition, the written value in EEPROM may be abnormal. So click
"Design value Rewriting" to write the initial value, then proceed with the operations.
Additional page
- L54-6･ AF-S DX17-55/2.8G -
INC
JAA78851-R.3617.A
November. 4. 2004