Installation Diagram Of Indoor And Outdoor Units - Toshiba RAS-24UKHP-ES-1 Service Manual

8-2. Installation Diagram of Indoor and Outdoor Units

5
Before installing the
wireless remote control
• With the remote control cover
open, load the batteries supplied
correctly, observing their polarity.
2
Wireless remote control
Cover
3
Batteries
18 Class
Heat pump
Loop the connective cable
(about 100 mm in diameter and 300 – 350 mm long).
7
Purifying filter
6
Zeolite filter
9
Filter frame
Pan head wood screw
2
Wireless remote control
Extension
drain hose
(Option:
RB–821SW)
Electric
parts
cover
18 Class
Cooling only
Loop the connective cable
(about 100 mm in diameter and 300 – 350 mm long).
1
Hook
Installation
plate
Shield
pipe
4
Remote control holder
Vinyl tape Apply
after carrying out
a drainage test
Saddle
Extension
drain hose
(Option:
RB–821SW)
Electric
parts cover
24 Class
– 31 –
FILE NO. SVM-03009
For the rear left and left
piping
Wall
Insert the cushion between
the indoor unit and wall,
and lift the indoor unit for
better operation.
Do not allow the drain
hose to get slack.
Cut the piping
hole sloped
slightly
Make sure to run the drain
hose sloped downward.
The auxiliary piping can
be connected the left, rear
left, rear, right or bottom.
Right
Rear
Rear
left
Bottom
Left
Insulate the refrigerant
pipes separately with
insulation, not together.
6 mm thick heat resisting
polyethylene foam