Steamout - Saeco Minuto Service Manual

MINUTO

5.4.2. SteamOut

Z1
Z2
Z3
To enter in SteamOut
The machine enters SteamOut mode by holding pressed together the Z2 button and the Z6 button
while switching on the machine.
Once entered the Steam Out mode the display shows the "STEAM Once entered the Steam Out mode the display shows the "STEAM
OUT" indication. Buttons can be released OUT" indication. Buttons can be released
IMPORTANT NOTE: to execute the Steam-Out procedure the IMPORTANT NOTE: to execute the Steam-Out procedure the
DREGDRAWER must be in place and the DOOR must be closed. DREGDRAWER must be in place and the DOOR must be closed.
If these 2 conditions are not respected a warning message is shown If these 2 conditions are not respected a warning message is shown
on the display and the Steam-Out is interrupted. on the display and the Steam-Out is interrupted.
The machine starts the Steam Out and the display change the The machine starts the Steam Out and the display change the
backlight (yellow) and appears the indication "ON". backlight (yellow) and appears the indication "ON".
While the Steam Out runs the Electrovalve is opened and water While the Steam Out runs the Electrovalve is opened and water
comes out the Water/Steam pipe. comes out the Water/Steam pipe.
When the Steam Out is complete the message "COMPLETE" is When the Steam Out is complete the message "COMPLETE" is
shown on the Display.The Electrovalve automatically closes and the shown on the Display.The Electrovalve automatically closes and the
machine can be switched off. machine can be switched off.
When the Steam-Out is complete the following parameters are reset to their default values: When the Steam-Out is complete the following parameters are reset to their default values:
Count Coffee Count Coffee
Aroma Aroma
Length Espresso product Length Espresso product
Length Medium Coffee product Length Medium Coffee product
Filter Presence Filter Presence
Filter Pulses Filter Pulses
Aroma Impulses Aroma Impulses
Dynamic threshold Dynamic threshold
History of grindings for Beans Presence detection History of grindings for Beans Presence detection
StandBy Time StandBy Time
The request for Priming the Circuit at the fi rst switch on is set. The request for Priming the Circuit at the fi rst switch on is set.
CLASS
for USA
Z7
05 TROUBLESHOOTING
FOCUS
for USA
Z4
Z5
Z6
Z4
Z5
Z6
Page / 46
29