Baxi windermere TF Installation And Servicing Instrucnions page 19

9.0 Annual Servicing – Page 19
Supplied By www.heating spares.co Tel. 0161 620 6677
9.5 Cleaning the Pilot (Fig. 41)
1. Undo the feed pipe from the pilot injector and pull the
lead off the ignition electrode.
2. Undo the two screws holding the pilot assembly
retaining plate. Remove the plate and withdraw the
electrode and pilot burner. Note the orientation of the
pilot burner outlet ports.
3. Pull the pilot injector from the burner and clean
carefully. Do not use pins or wires
4. Clean the pilot burner and electrode.
9.6 Cleaning the Burner and Injector
(Fig. 42)
1. Undo the screw retaining the injector cover to the
injector mounting plate and remove the cover. Undo the
nut on the injector feed pipe at the injector.
2. Remove the two screws securing the injector mounting
plate to the burner and undo the locknut retaining the
injector to the plate.
3. Carefully clean the injector with a soft brush.
4. Carefully brush the burner and ceramic inlays. Care
must be taken not to damage the inlays.
9.7 Completing Servicing
1. Examine the thermocouple and replace if necessary
(Fig. 41).
2. Clean any dirt and debris from the combustion box,
builders opening and the hearth under the stove.
Please read section 1.3 Important Information.
3. Reassemble the stove in reverse order of dismantling.
On RF models reseal the closure plate and reposition
the stove at least 15mm away from the plate.
4. Recommission the stove as described in section 6.0
Commissioning the Stove.