General Operation - McCulloch MC1275 Owner's Manual

GENERAL OPERATION

NOTE: Be sure that Water Reservoir has been filled and that all desired accessories are
connected before following these steps.
1. For first time use, remove protective plastic cover from electrical plug. Plug power cord into a
electrical outlet.
2. Switch Lighted On/Off Switch to "On" position. Steam Ready Light will immediately illuminate,
indicating that unit is heating.
3. Steam Ready Light will turn off in 2-8 minutes (depending on how much water is in Water Reser-
voir), indicating that unit is fully heated and ready to begin steaming.
4. Direct Nozzle (and any connected accessory) towards surface you desire to steam, and press
Steam Button. To sanitize surfaces, point Nozzle, press Button and hold approximately 1/2 inch
from surface for at least 5 seconds. This will insure that you have killed germs and bacteria.
CAUTION: Always be sure that Nozzle and any accessory are pointed in a safe direction
(away from yourself, other people, pets, and plants) before pressing Steam Button.
5. Keep Steam Button pressed for a continuous flow of steam. You may also slide the Steam Lock
Switch forward while pressing the Steam Button to lock it down. This will allow a continuous flow
of steam without need of holding the Button down manually.
6. Using a back-and-forth motion over the area you are steaming will further enhance the clean-
ing process. Wipe steamed areas with a clean cloth to remove loosened dirt and grime. Wip-
ing the area while it is still wet is recommended, but use caution when wiping surfaces such as metal
that may still be hot.
NOTE: During use, the Steam Ready Light may illuminate. This is normal. If you notice a
drop in steam pressure, release Steam Button until Steam Ready Light turns off again.
7. Once steaming tasks are complete, turn the unit "Off" and unplug. Follow steps under Proper
Storage procedure on Page 14 of this manual.
STEAM MOPPING
NOTE: Be sure that Water Reservoir has been filled and that all steam mopping accessories
are connected before following these steps.
It is recommended to sweep or vacuum hard floors before mopping.
1. Follow Steps 1-3 of General Operation section above.
12 | ENGLISH
Using Your Multi-Use
Steam Canister