Mitsubishi Electric PKH18FK Technical & Service Manual page 84

2-3. How to connect program timer
(1) Install the program timer next to the remote controller the same way as the remote controller is installed.
(2) Connect the program timer and the remote controller with a 6-wire cable as shown in the figure below
2-wire cable To indoor unit
Remote
controller
5-wire cable
Connector CN1
2-4 Names and functions
<PAC-SK65PT>
Mode dispay
Current time
display
Current day
display
Weekly timer
display
Set back
display
Daily timer dislay
NOTE : Display above
is only an exanple
3. TIMER ADAPTER
This adapter is needed for system control and for operation via external contacts. Adapter connection is described on page
57.
Part No.
ORN
BRN
RED
84
NOTE:While the program timer is connected to the remote controller, the
Program
timer
Connector CN1
Mode selector button : Using this button to select ¨MONITOR¨ or
¨MONITOR¨ : Indicates the current timer setting.
except
normal status.
¨SET¨ : ¨SET¨ is used to set the time, change the day of the
week, and program the daily and weekly timer.
SET MONITOR SET/MONITOR
CLOCK
BACK
TODAY
S M T W T F S
WEERLY
TIMER
GET BACK DEGREE
SET BACK
DAILY TIMER
ON SET BACK
MITSUBISHI ELECTRIC
Day setting button : Used to adjust the day of the week.
Weekly timer button : Used to set the weekly timer.
Set back button : Used to set the set back amount.
Daily timer button : Used to set the timer settings in units of 30
PAC-SA89TA-E
1
2
3
24hour ON/OFF timer on the remote controller will not operate.
¨SET¨ mode.
SET / MONITOR will not work. This is the
Clock adjustment button : Used to adjust the current time. Press
AHEAD
Each time the button is pressed the time
advances by 1 minute. Pressing continu-
ously advances 1 minute in a 0.5 second
interval. When the lower digit of minute
becomes 0 the indication advances in 10
minutes unit.
AHEAD
reversing the time. Each time the button
is pressed the time reverses by 1 minute.
ON OFF
Pressing continuously reverses the time
by 1 minute in a 0.5 second interval.
When the lower digit of minute becomes 0
BACK AHEAD
the indication reverses in 10 minutes unit.
OFF
BACK
Pressing button moves the day
light display in the order of S M T W
Set back can bee set in the range of 1 to 48˚F
in 34˚F unit.
minutes.
All buttons
button to advance the time.
BACK button is used for