Mitsubishi Electric PKH18FK Technical & Service Manual page 33

(3) Auto vane control
Auto vane position is set to 10degrees discharge at the start-up of COOL operation. It can then be changed by the remote
controller.
(a) Stop mode (fixed operation)
(!) At start-up of COOL operation, the auto vane is set to 10 degrees discharge direction.
(@) Discharge direction can be changed with AIR DISCHARGE UP/DOWN botton.
1 Fan speed : LOW
10°
discharge
2 Fan speed : HIGH
10°
discharge
(b) SWING mode
(!) The vane motor turns ON when the SWING mode is selected.
The vane motor is continuously ON during SWING mode.
(@) When SWING mode is changed to STOP mode, the discharge direction returns to the position of the last STOP mode.
<AUTO RETURN>
1 Fan speed : LOW
10°
discharge
2 Fan speed : HIGH
10° 30°
discharge discharge
When 60 degrees or 70 degrees discharge is selected with the LOW fan speed in COOL operation, "Auto RETURN" will
appear below the temperature display. One hour later, the discharge direction returns to 10 degrees automatically and
"AUTO RETURN" will disappear. If the discharge direction is set to 10 degrees during "AUTO RETURN" indication, the
time counting for AUTO RETURN is cancelled.
60°
discharge
30° 60°
discharge discharge
60° 70°
discharge discharge
AUTO AUTO
RETURN RETURN
60° 70°
discharge discharge
70°
discharge
70°
discharge
33