Table of Contents
Advertisement
Land Pride
Section 3 Adjustments
NOTE: Refer to Figure 3-6. The front brake link is not
adjustable.
Front brake link
(right side)
21058
Figure 3-6
2. Raise and block the tractor up so the drive wheels are
off of the floor.
3. Refer to Figure 3-7. Open the hydraulic pumps bypass
valve, on the side that is being adjusted, by turning
bypass valve counter clockwise one-half to one
revolution. The valve stems on each hydraulic pump
are located near the top and are identified as a hex
stud.
Bypass valve
Figure 3-7
4. Rotate the tire. The tire should rotate. Remember
hydraulic oil resistance will prevent the tire from
rotating freely even with the bypass valves open.
There should be no resistance from the brakes at this
point.
5. Refer to Figure 3-8. Move the control lever to where it
is just inside (1/8") the park brake slot.
*
Actual body and frame colors may be different than what is represented in the picture.
7/14/08
Table of Contents
Control Lever
21070
NOTE: Refer to Figure 3-9. When the control lever is
against the outside edge of the slot, the brakes
should not be engaged.
Control Lever
Travel Slot
Outside Edge
21071
21054
6. Rotate the tire. If the brake is adjusted properly the tire
will still rotate but friction will start to become
noticeable here. However, if no brake resistance is
noticed, the brake needs adjusted as follows:
ZRP44 & ZRP52 Zero Turning Radius Mowers
Control Lever Position*
Figure 3-8
Park Brake
Control Lever Position*
Figure 3-9
356-117M
Park Brake
Slot
1/8"
Slot
17
Advertisement
Table of Contents
