Structure Of This Manual - Fujitsu ETERNUS DX100 S3 Setup Manual

This manual provides a variety of operating procedures about Web GUI for the FUJITSU Storage ETERNUS
DX100 S3/DX200 S3 Disk storage system, the FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage sys-
tem, and the FUJITSU Storage ETERNUS DX200F All Flash Array (hereinafter referred to as "GUI"). It should be
referred to when setting up and configuring environment of the ETERNUS DX100 S3/DX200 S3 Disk storage
system, the ETERNUS DX500 S3/DX600 S3 Disk storage system, and the ETERNUS DX200F All Flash Array
(hereinafter referred to as "ETERNUS DX" or "storage system").
Knowledge of UNIX or Windows® system management is required.

Structure of This Manual

This manual consists of the following seven chapters and three appendices.
●
Chapter 1 Outline
This chapter provides an overview and explains the features, the operation environment, the user man-
agement function, and the screen operations for GUI.
●
Chapter 2 Startup and Shutdown
This chapter describes how to start, exit, log in and log out from GUI.
●
Chapter 3 Initial Setup
This chapter describes the initial settings for the ETERNUS DX storage systems.
●
Chapter 4 Configuration Settings for RAID Groups or Thin Provisioning
This chapter describes the RAID group settings for Standard volumes and Snap Data volumes. This chapter
also describes the Thin Provisioning Pool settings for Thin Provisioning volumes.
●
Chapter 5 Host Interface Management
This chapter describes the settings for host connection.
●
Chapter 6 Settings for the Advanced Copy Environment
This chapter describes the settings for an operation environment that uses the Advanced Copy functions.
●
Chapter 7 System Environment Settings
This chapter describes the key management settings that are used for encrypting authentication of Self
Encrypting Drives (SED).
FUJITSU Storage ETERNUS DX Configuration Guide (Web GUI)
Copyright 2014 FUJITSU LIMITED
3
Preface
Sixth Edition
September 2014
P2X0-1250-06ENZ0