Land Pride
Section 5: Maintenance and Lubrication
Lubrication Points
Lubrication
Legend
12726
12725
13667
7/28/06
Table of Contents
Multi-purpose
Multi-purpose
spray lube
grease lube
AFM4011, AFM4014 and AFM4016 All Flex Grooming Mowers 315-160M
Multi-purpose
oil lube
Driveline Constant Velocity Shaft
Type of Lubrication: Multi-purpose Grease
Quantity = See drawing
IMPORTANT: To extend the life of the constant velocity
joint, extensive lubrication must be performed every 8
hours of operation!
k. The constant velocity joint should be greased in a
straight position forcing grease through the
passages and into the cavity. After lubrication,
grease should be visible around the ball joints.
l.
The constant velocity driveline comes equipped with
a grease zerk in the outer telescoping member and
must be greased every 8 hours to prevent premature
failure of the joint.
m. Grease fittings are located on the u-joints and
driveline shields and should be lubricated every 8
hours of operation.
Driveline Shafts
Model 4011
Type of Lubrication: Multi-purpose Grease
Quantity = See drawing
Driveline Shafts
Models 4014 & 4016
Type of Lubrication: Multi-purpose Grease
Quantity = See drawing
Intervals in hours
50
at which lubrication
is required
8
Hours
25
Hours
25
Hours
31