Application (Example); Presets; Calling Up Presets; Editing Presets - Behringer X V-AMP User Manual

X V-AMP
Our example shows a typical X V-AMP application: Connection to a guitar amp (BEHRINGER V-TONE GMX212) using operating
modes A1-F3 (without speaker simulation). The V-TONE GMX212 features a stereo aux input, while many other amps have only a
mono instrument input. For jam sessions at your own pad, connect a set of high-quality headphones (e.g. our BEHRINGER HPS3000)
to the LINE OUT/PHONES connector.

4. PRESETS

Your X V-AMP features 100 user-rewritable presets (00 -
99). Each preset consists out of a maximum of 7 “ingredients”:
s amp simulation,
s speaker simulation,
s pre-amp effects (noise gate, compressor, Wah Wah),
s adjustable presence and bass EQs,
s modulation effect (e.g. phaser, chorus etc.),
s delay effect and
s reverb.
When the STORE key lights up, it means that a preset was
modified but has not been stored yet. When the STORE LED is no
longer on, the stored preset shown in the display is active.
When the STORE key blinks (briefly press STORE), you can use
the UP/DOWN footswitches (
storage space, where you can then store the current settings.
Storing is done by keeping the STORE key pressed longer than 2
seconds.
A single factory preset can be restored by keeping TAP +
STORE pressed for longer than 2 seconds. You can also restore
all factory presets by keeping TAP + STORE pressed for longer
than 2 seconds while you are powering up your X V-AMP.
When you dial up a preset or when editing a preset is complete,
the key LEDs indicate the active blocks.
8

3.2 Application (example)

Fig. 3.1: Standard application (example)
& ) to dial up another
4. PRESETS

4.1 Calling up presets

The preset you used last is always automatically recalled when
you turn your X V-AMP on.

4.2 Editing presets

Editing presets on your X V-AMP is quick and easy to do. One
way to do this is to call up a preset of your choice and then
modify it according to your own taste. Select an amp model of
your choice by turning the FX/AMPS control.
The STORE LED is lit up, signalizing that you have modified a
preset. If you now wish to add a modulation effect to this preset,
simply press the MODUL key
AMPS control to make a selection among the effects. To store
your settings, keep the STORE key pressed for about 2 seconds.
+

4.3 Storing presets

When the STORE key is blinking (briefly pressing STORE) you
can use the UP/DOWN footswitches (
another storage slot so you can store your current settings at
this location. You store your settings by keeping the STORE key
pressed for longer than 2 seconds.
. Now you can use the FX/
& ) to dial up