Online Registration; Control Elements And Connectors; Basic Advice On Using The Controls - Behringer X V-AMP User Manual

1.1.1 Online registration

Please do remember to register your new BEHRINGER
equipment right after your
www.behringer.com (alternatively www.behringer.de) and
kindly read the terms and conditions of our warranty carefully.
Should your BEHRINGER product malfunction, our goal is to have
it repaired as quickly as possible. To arrange for warranty service,
please contact the retailer from whom the equipment was purchased.
Should your BEHRINGER dealer not be located in your vicinity, you
may directly contact one of our subsidiaries. Corresponding contact
information is included in the original equipment packaging (Global
Contact Information/European Contact Information). Should your
country not be listed, please contact the distributor nearest you. A
list of distributors can be found in the support area of our website
(www.behringer.com/support).
Registering your purchase and equipment with us helps us
process your repair claims quicker and more efficiently.
Thank you for your cooperation!
2. CONTROL ELEMENTS AND
CONNECTORS
In this chapter, we will describe different control elements of
your X V-AMP. All controls and connectors will be explained in
detail, and you will also get useful advice on how to use them.

2.1 Basic advice on using the controls

Here is some quick information about the most basic and most
important control elements of your X V-AMP.
s Keys , , , and
select effects settings and operating modes.
s FX/AMPS control : Uset the right-hand half to select amp
simulations in a preset. The corresponding LED lights up. Use the
left-hand half to select the effects. When effects blocks are
selected using the keys ,
current effect lights up.
s TAP LED
the speed and/or the rhythm of a delay or a modulation effect
(also see chapter 6 “EFFECTS PROCESSOR”).
purchase by visiting
By keeping TAP depressed, 2
doing this, the second level of the FX/AMPS control
and ADJUST
s Footswitches UP
these presets are indicated in the DISPLAY
UP
TUNER function (also see chapter 7 “TUNER”).
s DISPLAY LEDs: PEDAL ASSIGN indicates the function to which
the pedal has been assigned. CONFIGURATION permanently
indicates the selected operating mode.
+
: use these keys to directly
and , the LED on the
Fig. 2.1: X V-AMP user interface

2. CONTROL ELEMENTS AND CONNECTORS

: The frequency at which the LED blinks indicates
FUNCTION
nd
is accessible.
and DOWN
and DOWN are also used to activate the BYPASS/
ADJUST: Used to perform various adjustments. You can
find more information about using ADJUST in the
descriptions of individual control elements as well as in
chapter 6 “EFFECTS PROCESSOR”.
GAIN. Use this control to regulate the drive of the amp
simulation, i.e. the degree of distortion. Use it when none
of the keys , , ,
VOLUME: If you hold the TAP key
ADJUST lets you adjust the volume of a preset.
STORE. The presets on the X V-AMP are saved using the
STORE key. If the STORE key lights up, it means that a
preset has been changed but has not yet been stored. By
keeping the STORE key depressed (longer than 2 seconds),
the newly edited preset is stored. When the STORE LED is
no longer lit up, the stored preset shown in the display is
now active.
X V-AMP
is activated. By
(gray)
: Used to select presets;
. Footswitches
or are blinking.
depressed, using
5