Table of Contents
Advertisement
Land Pride
Section 3: Adjustments
Section 3:
Adjustments
Center and Wing Section Leveling
These adjustments should be made with the cutter
hooked up to the same tractor that will be used for field
operations or one having the same drawbar height.
Cutter adjusting rods are set at the factory prior to
shipment. The adjusting rods control the draw bar height
at the hitch clevis.
Refer to Figure 3-1, Figure 3-2 & Figure 3-3:
1. Attach the cutter to the tractor and position it on level
ground.
2. Raise both wings to locked position.
3. See Figure 3-1. Using the hydraulic lift, adjust the
height of the center deck to 2-3 inch clearance
between the front skids (#2) and ground surface.
23574
Front Skid Position
Figure 3-1
4. See Figure 3-1. Level the left side of the center
section from front to rear using measurements from
ground line to center of left hand hinge rod (#1).
(See Figure 3-2) Loosen jam nut (#2) and rotate the
left hand leveling rod adjusting nut (#3) until the
center section is level. Re-tighten jam nut (#2).
5. Repeat steps 3 and 4 for the right hand leveling rod.
Be sure that both left and right leveling rods are
equally tight.
3
Center Section Leveling Rod
Figure 3-2
9/04/08
Table of Contents
Front Skid
2
15284
RCB6010 & RCB6015 (540 RPM) and RCMB6010 & RCMB6015 (1000 RPM) Rotary Cutters 318-263M
6. See Figure 3-3. Lower wings to ground position.
Wing sections may need adjusting now that the
center section is level. Loosen jam nut (#4) and
rotate the adjusting turnbuckle (#5) to desired
position. Re-tighten jam nut (#4).
5
Wing Leveling Turnbuckle
Figure 3-3
Cutting Height Adjustment
Refer to Figure 3-4:
The cutter comes standard with hydraulic height control.
Stroke control spacers are supplied to accommodate
various cutting heights.
Stroke Control
Spacers
Hydraulic Cylinder With Stroke Control Spacers
Figure 3-4
4
1
15285
15286
21
Advertisement
Table of Contents
