Maintenance And Troubleshooting - Weslo PRO 11.0x WLEX31810.0 User Manual

MAINTENANCE AND TROUBLESHOOTING

Inspect and properly tighten all parts of the exercise
bike regularly. Replace any worn parts immediately.
To clean the exercise bike, use a damp cloth and a
small amount of liquid dish soap. IMPORTANT: To
avoid damaging the console, keep liquids away
from the console and keep the console out of
direct sunlight.
CONSOLE TROUBLESHOOTING
If the console display becomes dim, replace all the
batteries at the same time; most console problems are
the result of low batteries. To replace the batteries,
see assembly step 7 on page 8.
If the handgrip pulse sensor does not function prop-
erly, see step 5 on page 14.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
To adjust the reed switch, you must first remove the
Left Shield (9). Using an adjustable wrench, turn the
Left Pedal (24) clockwise and remove it.
9
57
57
24
57
Next, remove the M4 x 16mm Screws (57) and the M4
x 25mm Screw (45). Then, carefully remove the Left
Shield (9).
Locate the Reed Switch (43). Turn the Crank (31) until
a Magnet (38) is aligned with the Reed Switch. Next,
loosen, but do not remove, the indicated M4 x 16mm
Screw (57).
31
Slide the Reed Switch (43) slightly closer to or away
from the Magnet (38), and then retighten the M4 x
16mm Screw (57). Turn the Crank (31) for a moment.
Repeat these actions until the console displays correct
feedback. When the reed switch is correctly adjusted,
reattach the left shield and the left pedal.
57
45
16
43
57
38