1-15.Controller {Optic n)
• Remote Controller AG-A600
Connection
Remote Controller AG-A600
1-16. Rack Mount Adaptor {Option)
The Rack Mount Adaptor AG-M730-E is used to mount the unit on the IEC standard rack.
Installation of the AG-M730-E
1.
Remove the 4 screws
from the side cabinet of the unit.
2.
Use the 4 screws supplied
with the AG-M730-E to install it to the unit.
I
Install It with the
notch down
The optional Remote Controller AG-A600 allows RECORD: PLAYBACK, FAST FORWARD, REWIND, PAUSE/STILL,
Mounting on the IEC standard rack
VARIABLE SPEED PLAYBACK (0-9 t1mes normal tape speed)
1n
forward or reverse direction and STOP operations. Operation
is possible with the unit's operation buttons even when the AG-A600 is connected to the unit.
Connection with the REMOTE Connector
&fi\mark~
.;:;::..
.::::::::
Press
Align the " .A. " marks and connect it to the REMOTE Connector
while keeping the cable connector button pressed.
1.
2.
Remove the 4 rubber legs
from the bottom of the unit.
Mount the unit on the rack.
•
Be sure to install a ventilation fan (air volume of about 3.3 m
2/sec.) on the top of the rack.
Installation of slide rails
•
Use a complete slide rail and bracket unit for 18" length (part
No. CC3004-99-0017) or 24" length (part No. CC3004-99-0018)
of Chassis Track. (The complete slide rail and bracket unit is
not available from Panasonic.)
•
When using the slide rail, remove the setscrews. The setscrews
can be removed by pulling in the direction of the arrow. Keep
the removed setscrews, washers and spacers in a proper
place.
• For the details, contact your authorized service personnel.
IEC standard rack
Fasten it to the
rack with
.._~::
Setscrew
Washer
Spacer
OPERATING INSTRUCTIONS-
Slide rail