Tape Interchangeability Adjustment Procedures; Tape Interchangeability Adjustment Procedures; Adjustment Flow Chart; Coarse Adjustment Of The Tape Guide Post Heights (P2 And P3) - Panasonic AG-7350 Series Service Manual

4-2. TAPE INTERCHANGEABILITY ADJUSTMENT PROCEDURES
4-2-1. ADJUSTMENT FLOW CHART
This flow chart describes the order of steps for adjusting the tape guide posts and NC head in order to gain access to the
Items needing servicing. (Figures M1 and M2)
AFTER RE-INSTALLING THE UPPER CYLINDER OR
LOWER CYLINDER
AFTER RE-INSTALLING THE A/C HEAD
I
4-2-7. FINE ADJUSTMENT OF THE NC HEAD HEIGHT
14-2-6. FINE ADJUSTMENT OF THE TAPE GUIDE POST
I
I.___ __
H_EI_G_H_T_(P_ 2 _A_N_D_P_ 3 _H_L.-IN_E_A_R_ITY) _ _ _ _ _ _
__J
4-2-5. TILT AND AZIMUTH ADJUSTMENT OF THE
I
~HEAD
14-2-9. FINE ADJUSTMENT OF THE NC HEAD
I
I
HORIZONTAL POSITION (X-VALUE)
AFTER RE-INSTALLING ALL POSTS OR IF ALL POSTS
HAVE BEEN TURNED EXTREMELY
4-2-2. COARSE ADJUSTMENT OF THE TAPE GUIDE
POST HEIGHTS (P2 AND P3)
4-2-3. ADJUSTMENT OF THE PULL-OUT POST (P5)
HEIGHT
4-2-5. TILT AND AZIMUTH ADJUSTMENT OF THE
NCHEAD
4-2-6. FINE ADJUSTMENT OF THE TAPE GUIDE POST
HEIGHT (P2 AND P3) (LINEARITY)
4-2-7. FINE ADJUSTMENT OF THE NC HEAD HEIGHT
4-2-7. FINE ADJUSTMENT OF THE NC HEAD HEIGHT
4-2-8. COARSE ADJUSTMENT OF THE NC HEAD
HORIZONTAL POSITION (X-VALUE)
4-2-9. FINE ADJUSTMENT OF THE NC HEAD
HORIZONTAL POSITION (X-VALUE)
AFTER RE-INSTALLING THE PULL-OUT (PS) POST
4-2-3. ADJUSTMENT OF THE PULL-OUT POST (P5)
HEIGHT
<<NOTE>>
Do not re-adjust any other posts.
Figure M1
Cylinder U n i t - - - - - - - ; ;
,
-~~~L__-==..._.:.::;'m,_nrF~iii~ii~-A/C
Head Azimuth Adjustment
~
Screw
--;--A/C Head Height Adjustment Nut
-~7-----A/C Head Horizontal Position
Asjustment Screw
==--==--"'=--=----A/C Head Azimuth Adjustment
Screw
'--------'!,!---::-;':;------Tape Guide Post (P4)
Tape Guide Post (P1)-------'~'
=::;.;~---------A/C
Head
~~p~ =--==~~--A/C
Head Horizontal position
~?1~"!1:'\'\'CP ~
Adjustment Screw
~=='::':;8~~~~~-------Pull
Out Post
Figure M2
4-3
1-
z
w
:E
l-
en
:::)
..,
c
<(
..J
<(
0
z
<(
:t:
0
w
:E