Memory Stop Functions; Sensor Recording (Ag-7350 Only) - Panasonic AG-7350 Series Service Manual

1-5. MEMORY STOP Functions
1.
2.
3.
4.
5.
[liT
5
Press the RESET Button at the
point to be automatically stopped.
• The tape counter will be reset to "0:00:00".
Press the SCREEN DISPLAY
Button.
• The ON-SCREEN menu will be displayed on the TV monitor.
Press the OAT A or MEMORY Button.
• Select the "MEMORY STOP" mode.
MEMQRXSl:OP
BGN+O : 00 : 00
END+O: 00 : 00
' - - - - - - _ j (" •000"" lamp lights up in the counter.)
Press the SCREEN DISPLAY Button.
• The normal picture will appear.
Press the FF or REW Button.
• When the FF or REW Button is pressed, the tape will be
wound and then stopped automatically around the tape
counter position "0:00:00".
2,4 1
RESET ME}.10RY BEGIN END
~CJ
CJ CJ
SCREEN DISPLAY SHIFT
DOWN DATA
~CJ CJ CJ
SCREEN DISPLAY SHIFT DOWN DATA
CJ CJ CJ ~
or
RESET MEMORY BEGIN END
CJ ~CJ CJ
SCREEN DISPLAY SHIFT DOWN DATA
~CJ CJ CJ
REW FF
~
or
~
Notes
• MEMORY STOP function is also available by just pressing the MEMORY Button at the position except "0:00:00"
after step 1 described above.
• When finished with this function, be sure to select "MEMORY OFF" in step 3 described above. ("--+000" lamp goes
off in the counter.)
1-6. Sensor Recording (AG-7350 only)
Model AG-7150 is not equipped with recording function.
The unit allows to start recording automatically if a video input signal is supplied to the unit from an external source such as a
satellite, etc.
1.
2.
lc=
1---HIE3l
~~~~~======~~~==~~
Turn on the unit and insert a
video cassette.
2
Make sure that the erasure prevention tab on the video cas-
sette is intact.
Set the SENSOR REC Selector.
In case of "VIDEO" setting:
• The "SENSOR" indicator will appear on the tape counter and
the unit will be set to the standby mode. When a video signal
is inputted into the VIDEO IN Connector. the unit is turned
on and set to the recording mode. When there is no more
signal, the unit will go into the stop mode and, after a while,
be set to the standby mode again.
In case of "REMOTE" setting:
• The "SENSOR" indicator will appear on the tape counter and
the unit will be set to the standby mode. When a recording
start signal is inputted into the SENSOR REMOTE Connec-
tor on the rear panel, the unit is turned on and set to the
recording mode. When a recording end signal is inputted,
the unit will go into the stop mode and, after a while, be set
to the standby mode again.
• The tape position where the SENSOR recording started also
becomes the beginning position of the REPEAT playback.
Similarly, the tape position where the recording ended be-
comes the end position of the REPEAT playback, and the
repeat mode is automatically set to "REPEAT CONTINUE".
r---· - - - - -
1
l _ _ _ _
REMOTE~
OFF
E3
VIDEO
SENSOR RE:
1
Notes
• The "SENSOR" indicator will blink if no video cassette or a video cassette with its erasure prevention tab broken off
is inserted in the unit after the SENSOR REC Selector is set "VIDEO" or "REMOTE".
• When the tape reaches its end during the SENSOR recording, the unit is set to the stop mode and turned off.
• Any operation buttons are inoperative after the SENSOR REC Selector is set.
OPERATING INSTRUCTIONS