Detailed Set-Up Guide; Battery Installation - La Crosse Technology WS-7038U Instruction Manual

DETAILED SET-UP GUIDE

I)

BATTERY INSTALLATION

Note: Batteries will fit tightly. To avoid start-up problems make sure that the
batteries do not spring free.
A) RAINFALL TRANSMITTER
1. Remove the flat-head screw and
battery cover, located on the
underside of the base.
2. Observe the correct polarity,
and install two AA batteries.
3. Make sure the rubber weather
seal is in place and replace
the battery cover and screw.
4. Separate the base by turning
the rainfall collector in a
counter-clockwise direction.
Remove the tape from the
teeter-totter. Replace the
cover.
B. RAIN MONITOR
1. Remove the battery cover on the backside of the unit.
2. Observe the correct polarity, and install 2 AAA batteries.
3. Replace the battery cover.
Note: After the batteries have
been installed, the entire LCD
(Liquid Crystal Display) will
light up briefly, then the default
settings will be initiated.
Battery compartment
4
Battery cover
Teeter-
Totter
Battery
Compartment
Battery Cover