Sony HVR-A1J Service Manual page 260

3-29. Cam Gear Ass'y
1. Removal procedure
Remove the screw (special head screw M1.4 × 1.4) 1.
1)
2) Remove the cam gear ass'y 2 from the cam gear shaft.
Apply grease
Apply grease when installing
Amount of grease: A ball of
grease of 1.0 mm diameter
Side of inside
HVR-A1J/A1U/A1N/A1E/A1P/A1C
Points
to be noted
Cam gear assy
Cam gear assy
Key Points
in Re-assembling
Mode gear assy
Cam gear assy
2. Attachment procedure
1) Apply grease on the specified locations of the cam gear ass'y 2.
2) Move the mode slider ass'y in the direction of arrow A as far
as it can go.
3) Align the gear phase of the mode gear ass'y and the cam gear
ass'y 2.
4) Install the cam gear ass'y 2 while engaging the dowel B of
the mode slider ass'y into the groove of the cam gear ass'y.
Install the screw (special head screw M1.4 × 1.4) 1.
5)
1 Screw
(M1.4 × 1.4)
2 Cam gear ass'y
Dowel B
Cam gear assy
Dowel B
A
Mode slider assy
6-101
Amount of grease: A ball of grease of 1.0 mm diameter.
Tightening torque: 0.04 ± 0.01 N•m (0.61 ± 0.1 kgf•cm)
Mode gear ass'y
Cam gear shaft