Getting To Know Your Cleaner; Using Your Cleaner; Assembling Your Cleaner - Hoover Vacuum Cleaner User Manual

GETTING TO kNOw yOUR ClEANER

A. Cleaner main body
B. Dust container
C. Dust container front handle*
D. Dust container top handle
E. Dust container release button
F. On-off / power control* slider
G. Cleaner carry handle / cord rewind button
H. Parking slots
I. Exhaust filter
J. Hose
K. Hose release button
L. Handle
M. suction control
N. standard tube*
O. Telescopic tube*
P. Telescopic tube adjuster*
Q. Carpet and Floor Nozzle(GP)**
Q1. Carpet Nozzle (CA)**
Q2. Hard Floor Nozzle (HF)**
R. surface selector pedal**
s. Pre motor filter
T. Pre motor filter mesh*
U. 2 In 1 accessory
V. Pet hair remover mini turbo nozzle*
W. Allergen remover mini turbo nozzle*
X. Grand turbo nozzle*
Y. Hard floor caresse nozzle*

ASSEmblING yOUR ClEANER

Remove all components from the packaging.
1. Connect the hose to the cleaner main body, ensuring it clips and locks into position.
To release: simply press the button on the hose end and pull. [2]
Connect the handle to the tube upper end. [3]
2.
3. Connect the tube lower end to the carpet and floor nozzle**. [4]
*Certain models Only ** Certain models only, nozzles may vary according to model

USING yOUR ClEANER

1. Extract power cord and plug it into the power supply. Do not pull the cord beyond
the red marker. [5]
2. Adjust the telescopic tube* to the desired height by moving the telescopic tube
adjuster* up and raise or lower the hose handle to the most comfortable cleaning
position. [6]
3. select the type of surface to be cleaned by pressing the pedal in the nozzle**. [7]
Hard Floor – Brushes are lowered to protect the floor.
Carpet – Brushes are raised for the deepest clean.
switch the cleaner on by sliding the On-Off control to the ON position. [8]
4.
5. Adjust the power level by further sliding the On-Off /variable power control* slider
on cleaner mainbody. [9]
6. switch off at the end of use by sliding the On-Off control to the OFF position. Unplug
and press the carry handle/cord rewind button to wind the power cord back into the
cleaner. [10]
7. To store your cleaner adjust telescopic tube* to the lowest height setting and park
the nozzle in the park position on the cleaner main body. [11]
ACCESSORIES ANd NOzzlES
To obtain the best performance and energy efficiency
correct nozzles are used for the main cleaning operations. These nozzles are indicated
in the diagrams by the letters GP, HF or CA.
A nozzle type GP can be used to clean both carpet and hard floor.
A nozzle type HF is suitable for use only on hard floor.
A nozzle of type CA is suitable for use only on carpet.
The other nozzles are accessories for specialist cleaning tasks and are recommended
for occasional use only.
It is important to note that this vacuum cleaner is supplied with an Energy Label as re-
quired by European Regulation (EU) 665/2013.
If the label shows a red prohibition circle on the left covering the carpet symbol, then this
indicates that the vacuum cleaner is not suitable use on carpets.
If the label shows a red prohibition circle on the right covering the hard floor symbol, then
this indicates that the vacuum cleaner is not suitable for use on hard floors.
#1
NOTE: Dust pick up ability carpet, dust pick up ability hard floor, and energy efficiency
in accord with Commission Regulations (EU) 665/2013 and (EU) 666/2013.
2
#1
it is recommended that the