Now We Install The Dispenser - InSinkErator Hot-1 The Installation, Care And Use

2
A
Mount the unit through the 1-3/8" dia. (35
mm) hole in the sink (see note below). Make
sure the valve lever is in the up position and
feed the spout end of the dispenser through the
sink mounting hole.
Note: To fit the unit through the sink
hole, it will be necessary to remove
the spout. To remove, loosen the set
screw in spout holder approximately
two full turns and pull out spout. After
mounting dispenser in sink, reassemble
the spout making sure the rubber seal
on spout is in place (see sketch below).
Push spout into dispenser as far as it
will go and retighten set screw
approximately two turns.
Failure to tighten set screw allows easy
removal of spout. Operation of unit with
spout removed could cause injury from
hot water spray.
DO NOT plug in the electrical supply cord until the tank is full of water

Now we install the dispenser

'A'
Personal Injury
Spout & spout holder
should not be loose
after mounting.
First tighten
mounting nut
'B' and then
tighten wing
nut 'C'
securely.
B
While holding the dispenser in place with
spout removed, slip the rubber gasket and
mounting nut over the valve lever and hand
tighten the nut on the threaded barrel.
Align the spout so that the water will run
C
into the sink and secure the dispenser by
tightening the wing nut from the underside of
the sink.
Important: First ensure mounting
nut B is fully engaged and tightened.
Then tighten wing nut C securely.
The spout and spout holder should
not be loose after tightening
mounting nut B
and wing nut C.
Note: The
dispenser must
be mounted in the
upright (vertical)
position only.
'B'
'C'