Table of Contents
Advertisement
•
If the auto calibration fails, the error message will appear. Please perform the auto calibration again.
•
Before performing the auto calibration again, please check the following situations.
1. Turn off the lights to darken the surroundings and reduce the reflection of external light to the
projection screen.
2. Readjust the focus again.
•
If the auto calibration fails again, please perform the manual calibration.
5) Click the SPdriver6 icon on the taskbar and select the pop-up "Manual" to display the
manual calibration screen.
6) Press the target mark in the screen with the Pen.
•
Each time you press the target mark, the moving order is .
7) Press the target mark .
•
The "Please wait..." message appears, and after completing the process the message will disappear.
Attention
• When carrying out the "Auto", make sure to project image onto a smooth screen.
Note
• When the position of the screen and the projector is fixed, there is no need for calibration again next time if you use the same
computer at the same resolution.
Please use the LightPen to touch the target marks on the screen.
(If you would like to quit the calibration process, please use the
"ESC" key.) After the 4th point of calibration is finished, please
wait for 2 secs while data is saved.
For Windows
(continued)
7
Advertisement
Table of Contents
