Table of Contents
Advertisement
8
Installation
1. Verify compatibility. Certain radios require antenna
adapter(s) that are not included in the kit.
2. Disconnect the battery.
3. Remove the radio from the car.
4. Set the DIP Switches for the Frequency Selector
Switch to the desired setting. See page 6.
OFF
ON
12
5. Install the Universal cable. Plug the factory radio
antenna into the receptacle on the Interface
Module.
6. Test for 12V constant, 12V switched, and ground
sources. Splice into the sources with leads from
the power cable.
7. Route the Interface Module to the glove box or
another accessible location.
Advertisement
Table of Contents
