Table of Contents
Advertisement
8. Connect the BCS1M Bluetooth Module.
9. Mount the BCS1M Bluetooth Module in a suitable
location as per the illustration. Use the included
2-sided tape or the clip. Make sure the built-in
microphone is directly facing the driver.
10. Connect the battery and test.*
11. Complete the installation by re-installing the radio.
12. Save the frequency to a preferred preset on the
radio if desired.
*CAUTION: Do NOT connect any mini-DIN and iPod cable used on
other Audiovox products to the mini-din port. Failure to follow this will
Optimal Sticky Mount
Acceptable Sticky Mount
cause permanent damage to the unit/iPod!
Clip Mount
Avoid
9
Advertisement
Table of Contents
