PRESONUS AudioBox 44VSL Quick Start Manual page 59

Owner's Manual
Software: Virtual StudioLive and Studio One Artist
To control the overall amount of the effects you will hear in your mix, use
the FX A and FX B faders. These will raise and lower the 100% wet effects
mix.
Above each effects fader, you will see the individual parameter
controls. These allow you to adjust the effect to taste.
• Reverb: Pre delay. This is the time between the end of the initial
sound and the moment when the first reflections become audible.
• Reverb: Room size. This allows you to adjust
the size of your virtual "room. "
• Reverb: Width. The width control increases
the stereo width of the reverb bus.
• Delay: Delay Time. This is the time between
the source signal and its echo.
• Delay: Feedback. Variable feedback, or regeneration,
produces multiple decaying repeats.
• Reverb and Delay: Damping. This control dampens
the higher frequencies in the reverb reflections.
AudioBox 44VSL users: It is important to mention both FX bus A and FX bus
B must be patched to an output pair in order to hear them in the mix. On
each of the output buses (Out 3 and 4 and Main), you will see buttons
labeled FXA and FXB. These buttons route the output of the FX buses to
the physical outputs on your interface. By default, both FX buses are
routed to all outputs.
4
Virtual Studio Live 4.1
31