Name And Function Of Parts - Sony CA4000 Operation Manual

Name and Function of
Parts
Top Panel
1
2
3
4
5
6
7
Note
In systems connected to an F65, the following handle
functions a to j cannot be used.
a INCOM (intercom) button (SY model) / ENG (engineer
line) button (CE model)
SY model: Turns the intercom microphone on while this
button is pressed.
CE model: Turns the intercom microphone on and selects the
engineer line while this button is pressed.
You can also assign other functions using the menu.
b RET 1 (return video 1) button
Monitors the return video 1 signal from the CCU in the
viewfinder while this button is pressed. It has the same
function as the RET 1 button (page 9) on the rear operation
panel.
You can also assign other functions using the menu.
c Accessory shoe
Attaches to accessories that using a 1/4 inch screw.
d Front tally
Displays a tally light, for example, in response to a tally input
on the connected camera control unit or a call signal is initiated
by pressing the CALL button.
e Viewfinder shoe
Attaches to a viewfinder.
For details about attaching, see "Attaching a Viewfinder"
(page 13).
8

Name and Function of Parts

f Handle slide button
Releases the handle while this button is pressed, allowing the
handle to slide when adjusting the position of the handle.
g Camera mounting screws
Attaches the unit to the camera.
h Microphone holder shoe
Attaches to a microphone holder.
i Handle position lock lever
Locks the handle in position.
Turn the lever counterclockwise to release the handle to adjust
the handle position. After adjustment, turn the lever clockwise
8
to lock the handle in position.
9
j Handle flip-up lock release button
Flips up the handle while this button is pressed.
k CAMERA POWER switch
CCU: Turns on the power supply from the camera control unit.
EXT: Turns on the power supply from the DC IN connector.
Used when using the unit in extension mode.
0
Rear Panel
qa
1
2
a Operation panel (See "Operation panel")
b Connector panel (See "Connector panel")
c BPU (Baseband Processor Unit) connector
(optoelectrical connector)
Connects to a Baseband Processor Unit using an
optoelectrical cable.
d VF-B (viewfinder B) connector
Connects to a DVF-series viewfinder (option).
e VF-A (viewfinder A) connector
Connects to an HDVF-series viewfinder (option).
3
4
5
6
7
8
9