Initiarize; Exit; Others - Yamaha RM1x Service Manual

RM1x
Keyboard Velocity setting = 100
Event Chase =
Setup Mode =
Song Number =
Rec. track =
Pattern Number =
Section =
REC MODE =
Phrase Rec. Loop =
Rec. Pre. Count =
Tempo =
Rhythm =
Transpose =
Jump Type =
C-25 EXIT

25: Exit

When the RM1x exits the test program, the
RM1X becomes the play mode. When this test
is executed, the following display will appear.
25: Exit
[NO] or [YES] ?
[YES] : exit the test program.
[NO] : return the test entry mode.
D. OTHERS
When the power switch is turned ON and
OFF, confirm that the clicking noises of the
OUTPUT and PHONES are less than 0.5V p-p.
When the RM1x exits the test program and
returns to play mode, confirm that the noise
levels of each output are as follows.
(
A JIS-C curve filter is required for the measurements.)
OUTPUT (L) ------------> less than -78 dBm
OUTPUT (R) ------------> less than -78 dBm
PHONES (L) ------------> less than -78 dBm
PHONES (R) ------------> less than -78 dBm
Confirm that the RM1x starts on a usual initial
screen when you turn on the power switch
again after the Factory Set is executed in " A
HOW TO ENTER THE TEST PROGRAM " ,
the power switch is turned off and three
minutes or more pass.
When the RAM data are destroyed, " Backup
Battey Low " or " Factory Set " is displayed.
32
OFF
Pattern Mode
1
1
Preset 001
A
Step Rec. Single
Track Recording
ON
1 Ber
120.0 bpm
4 / 4
0
OFF

2. INITIARIZE

If you wish to reset the RM1x's settings to the factory condition,
you can perform the Initialization operation.
1 While holding down the [OCT DOWN] and [OCT UP]
# b
buttons and the F /G key [ALL] located at their right, turn on
the STANDBY/ON switch.
2 When "RM1x" appears in the display, release the keys.
3 When initialization has been performed, "Factory Set"
appears briefly in the display.
CAUTION!
When initialization is performed, all internal memory will be
erased. If you wish to keep any of your data, you must save
it to floppy disk before initializing.