If Other Trouble Occurs - Kyocera copier Operation Manual

If other trouble occurs

If trouble occurs with your copier, carry out the applicable checkpoints and procedures indicated on the following pages. If the trouble persists,
contact your service representative or authorized service center.
Trouble
Nothing lights on the
operation panel when the
power switch is turned ON.
No copies come out when the
Start key is pressed.
The copies come out blank.
The copies come out too light.
The copies come out too dark.
The copies are dirty.
Checkpoint
Is the power plug connected to an AC
outlet?
Is there some indication of the trouble on
the operation panel?
Were the originals set correctly?
Is the copier in the Auto Exposure
Adjustment mode?
Is the copier in either the Photo, Text &
Photo, or Text mode?
Is the copier in the Eco-Copy mode?
Is the Add Toner indicator lit?
Is the copy paper wet?
Is the copier in the Auto Exposure
Adjustment mode?
Is the copier in either the Photo, Text &
Photo, or Text mode?
Is the platen or the optional Document
Processor dirty?
Section 8 TROUBLESHOOTING
Procedure
Connect the plug to an AC outlet.
Check the appropriate response to that
indication and perform the corresponding
procedure.
When setting originals on the platen, set
them face-down.
When setting originals in the optional
Document Processor, set them face-up.
In order to adjust the overall exposure
level, perform the "Auto Exposure
Adjustment" procedure.
Adjust the exposure to the correct level
using the copy exposure adjustment keys.
To adjust the overall exposure, perform
the corresponding exposure adjustment
procedure.
Select an image quality mode other than
the Eco-Copy mode.
Replace the toner container.
Replace the copy paper with new paper.
In order to adjust the overall exposure
level, perform the "Auto Exposure
Adjustment" procedure.
Adjust the exposure to the correct level
using the copy exposure adjustment keys.
To adjust the overall exposure, perform
the corresponding exposure adjustment
procedure.
Clean the platen and/or the optional
Document Processor.
Remove the Process Unit and perform the
cleaning operation on the charger.
Reference
Page
—
8-1
4-2
7-2
6-1
4-2
6-1
4-1
9-2
3-1
6-1
4-2
6-1
9-1
9-4
8-9