Table of Contents
Advertisement
Chapter 5
Network Setup
Table 5-1
Option
Enable ONVIF
IP Addressing Window
The IP Addressing window provides options for configuring the IP address of the IP camera.
To display the IP Addressing window, perform the following steps:
Procedure
From the IP camera user interface, click the Setup link.
Step 1
Click Network Setup to expand the menu.
Step 2
From the Network Setup menu, click IP Addressing.
Step 3
The IP Addressing window appears. If you change any options in this window, you must click the Save
button to save the changes. If you do not click this button, changes are not retained when you exit the
window. The Save button appears at the bottom of the window. You might need to scroll down to it.
Table 5-2
ë
Table 5-2
Option
IP Addressing Area
IP Version
OL-32285-01
Basic Window Options (continued)
Description
Check this check box if you want the IP camera to work in Open Network
Video Interface Forum (ONVIF) mode.
The following features are supported:
Device Discovery Service
•
Device Service
•
Media Service
•
Enabling ONVIF disables SessionID as indicated by the informational
message that appears after you click the check box.
Click Save to be redirected to the login page. After login, ONVIF service
starts working. You can verify this service by using any ONVIF tool.
By default, ONVIF is disabled.
We recommend that you do not enable ONVIF when using Cisco
Note
VSM to avoid conflicts with configuration.
describes the options in the IP Addressing window.
IP Addressing Window Options
Description
Choose the IP version from the pull-down list. Currently, only IPv4 is
supported.
Cisco Video Surveillance 3000 Series IP Camera Configuration Guide
IP Addressing Window
5-3
Advertisement
Table of Contents
